Instruction Manual

Troubleshooting
Created by EBCCW 00:06
37
5683EN-1
13 Troubleshooting
13.1 Jerky running
13.2 Drive unit is running, conveyor belt is not
13.3 Motor overheating on drive unit
Cause Corrective action
Damaged or badly fitted
slide rail
Inspect and replace as necessary.
Wrongly adjusted slip
cl
utch
Check and adjust slip clutch.
Worn transmission parts Check/replace transmission belt, belt
drive sprocket.
Conveyor belt is too tight/
loose
Tension conveyor belt correctly.
Dirty conveyor Clean conveyor belt/slide rail. Lubricate
with silicone based lubricant.
Cause
Corrective action
Wrongly adjusted slip
clutch
Check adjustment of slip clutch.
Friction discs in slip clutch
are w
orn or contaminated
Check and replace if necessary.
Damaged/badly fitted slide
rail
Check the free running of the conveyor
belt.
Transmission products are
not fit
ted
Check and fit.
Cause
Corrective action
Overloaded conveyor Remove products from conveyor and test
run.
Check actual conveyor load against rec-
ommended loading.
Gearbox leaking oil Check output shaft seal and area around
motor/gearbox interface.
Dirty conveyor Clean the conveyor belt with warm water
(50°).