Instruction Manual

Belts
Created by EBCCW 00:06
25
5683EN-1
5. Press the rod into the belt until it "snaps" in place.
6. Continue inserting required number of belts. When the total number of
belts are installed and stretched, there should be a total slack of 200-
300 mm compressed belt for the whole belt length.
200-300mm
7. Fitting the belt in the drive unit.
It is important the belt fits into the co
gs. If the belt is not properly fitted
on the cogs, it will bypass the teeth of the cogs when operating the
conveyor.