User Manual

Unload the Spiral Elevator
Page 26 of 68
5478EN-3
• Re-attach the frame with feet, to the final position at the bottom of
the Spiral Elevator column. Attach the stay brackets between the
Spiral Elevator column and the bottom frames.
• Remove feet from the now horizontal position and re-fit in to the
other holes in the frame to have the feet in the vertical position.
• Check all bolts for the lower frames, feet and stay brackets are in
place and secure.
• Lower the Spiral Elevator down on to the floor.
• Move the Spiral Elevator in to final position taking care not to place
undue side load on the feet to avoid damage. If the Spiral Elevator
is moved using a ForkLift truck or Pallet Truck, great care must be
taken due to the height of the Spiral Elevator to ensure that it does
not topple over.
• The feet can be adjusted to give the correct height. Make sure all
four feet are adjusted evenly.
. Note! Carry out these operations calmly in order to be able to
carefully monitor any movement of the Spiral Elevator.
. Warning: It is forbidden to walk under the Spiral Elevator
duringthe procedure of rising to the upright position.
. Note! Make sure that while raising the Spiral Elevator that there
are no unauthorised persons near the Spiral Elevator.