Installation Guide

Step 3
03
Step 4
04
Step 6
2
1
2
3
Step 5
Power port
Port for cable
connected to
the leg
Port for
handset
Install the pedestal (1)
Attaching the lifting column (2) to the pedestal (1) using 8 M6x16mm bolts (C).
Tighten with 4x4 hex key (F).
Install the desktop
Use method 2 in Step 6 to install the desktop, when the
desk frame is stretched to more than 1720mm.
Install the handset and control box.
Connect the cables to the control box as shown in the diagram below.
Method 1
First screw the M6 bolts (B) to the supporting beam (4) by using 4x4 hex key (F), not too tight.
Then press one side of baffle (3) and make it inserted to the M6 bolts (B), then insert the other
side. After that, tighten the M6 bolts (B) up.
1. Insert one side of baffle (3).
2. Press the other side of baffle (3).
3. Tighten
Method 2
Tighten
Loosen
Stretch
C
x8
F
4x4
B
x4
F
4x4
E
x12
B
x4
F
4x4
D
x4
Install baffle
F
4x4
1
A C
H S
M 1 M2 D C
Adjust the distance according to the actual
size of the desktop.
Install the baffle (3) like method 1 in Step 6.
Note:
The supporting beam can not be
stretched exceeding this hole.
When the desk frame is stretched
to more than 1720mm, install
the baffle (3) to the middle connecting
bar in beam(4).