CONTENTS {Dr preexist Diagram of Components 0 1 Accessory List 0 2 Installation 03 How to Use 1 5 Troubleshooting and Attention 1 7 Warranty 1 9
Diagram of Components TTT Supporting beam Fleshpot Keypad Side bracket x2 Lifting column Power plug Feet a Me. all Se Cable management net Control box Velcro 1 Accessory Package Please contact customer service if there are any accessories or tools missing.
Flatfoot Step 1 3 ko EES Ax1 Cx8 Max. Load Capacity 440 Ibs (200 kg) Max. Speed 1.5%s Attach the side brackets to the beam Adjustable Height Range 23.8" -49.4" (605 1255mm) ; wide Expand (1100 1900mm) pi Length: 70.9" -94.5" (1800mm 2400mm) Applicable Desktop Size Width: 31.5" 35.4" 800mm 300mm Installation Process Pr-installation Guide Tips: Use the two small blue boxes in the package Assemble on a foam Get a friend for help Prepare a drill to cushion the beam for easier installation.
Installation Process Step 2 wl Adjust the length of the supporting beam a) Turn over the frame. Loosen the four screws of the frame and stretch the frame. b) When there are holes on the table top, the beams are stretched to align with the holes; when there are no holes on the table top, the support plates on both sides are installed close to the edge of the table top.
Installation Process Step 4 install the leg columns Step 5 Attach the feet Fasten the screws as seen.
Flatfoot Step 6 | Step 7 Fx2 Better use the drill Fx2 Better use the drill Fix the keypad Attach the control box Tips: You can install the keypad on either edge depending on your hand preference.
sel ee Installation Process . Fleshpot ¥ Pe Step 8 Step 9 Bx6 Better use the drill Connect the wires Install the string net hook Tips: When the table board has holes, the position of the hook is charity according to the holes; Connection of the same color. When the table board has no holes, the net can be laid flat to determine the position of the hooks.
Installation Process Installation Process fe Brriexispot Step 10 Step 11 Attach cable management net Finished: Turn over the desk, make sure the keypad is facing upwards along the process.
15 LED display Windowpane 3 height preset Attention Please make sure that there are no obstacles in the process of raising and lowering the table, and ensure that all lines are long enough to move the table up and down. Saving the Height Press "M". The display will show Then press the button "sI", "5-2" or The current height will be saved to the corresponding position. After saving the height, you can press the or "3", and the desk will automatically adjust to the corresponding height position saved before.
Troubleshooting-1 This list is used for checking and solving common faults and errors. Please contact the manufacturer if problem you encounter is not on the list below. Laddie No response wham pressing the UP button and DOWN button “ » Check the cable connection. £DFiexispot Speed of lifting is slow Work surface downward sliding or automatically reset a lot Check If the load weighs more than 440 Ibs.
Fleshpot Limited Warranty This limited warranty offered flexibility covers defects in material or workmanship in new Fleshpot products. This warranty extends to the original purchaser only and is non-transferable. Only consumers purchasing Fleshpot products from authorized Fleshpot retailers or resellers may benefit from our limited warranty.
