Installation Guide

Step 4: Attach and fix the upright support
Attach the upright support beam (1) to the top wall plate (2) and fix and tighten with bolt (B).
Fix the bottom wall plate (3) using washers (B3) and lag bolts (B1).
Fix the bottom wall plate (3) using plastic expansion bolts (B2), washers (B1) and lag bolts (B2).
Step 3: Mark the holes for the bottom wall plate assembly
Level
1. Mark the holes according to the placement of the bottom wall plate.
2. Drill a 2.8'' (70mm) deep 0.2'' (5mm) diameter pilot hole using 3/16'' drill bit at the center of
each marked point. (Hole size refers to Step 1 - Option A.)
Pistol-Grip Drill
Hammer Drill
1. Mark the holes according to the placement of the bottom wall plate.
2. Drill a 2.8'' (70mm) deep 0.39'' (10mm) diameter pilot hole using 3/8'' drill bit at the center of
each marked point. (Hole size refers to Step 1 - Option B.)
05 06
Step 3 - Option A: Wood Stud Installation
Step 3 - Option B: Solid Concrete Wall Installation
Step 4 - Option A: Wood Stud Installation
Step 4 - Option B: Solid Concrete Wall Installation
Level
3
1
2
B
B1
B3
B
x1
B1
x4
B3
x4
B
x1
B1
x4
B2
x4
B3
x4
1
3
2
B
B1
B3