Installation Guide

A B C D
M8x22mm
Bolts
(2 pcs)
Magnetic level
(1 pc)
M5x25mm
Bolts
(1 pc)
E
M6x25mm
Bolts
(4pcs)
F
Anti-loose Nut
(2 pcs)
Step 1 - Option A: Attach the top wall plate to wood studs
1. Use the stud finder to locate the wall studs.
2. Place the magnetic level to the top wall plate (2). Marking the mounting holes using the wall
plate. Pay attention to the holes placement and the distance between two holes, as shown on
the figure.
3. Drill a 2.8'' (70mm) deep 0.2'' (5mm) diameter pilot hole using 3/16'' drill bit at the center of
each marked point.
4. Attach the top wall plate to the wall studs using washers (B3) and lag bolts (B1). Tighten with
socket wrench.
2.8'' (70mm)
Φ3/16'' (5mm)
Stud Finder
Pistol-Grip Drill
/Hammer Drill
Screw Driver
01 02
1. THIS IS A DO IT YOURSELF (DIY) PROJECT. DO NOT ATTEMPT THIS INSTALLATION WITHOUT
A BASIC UNDERSTANDING OF THE CONTENTS IN THESE ASSEMBLY INSTRUCTIONS.
2. THERE ARE TWO INSTALLATION OPTIONS FOR WALL STUDS OR SOLID CONCRETE WALL.
PLEASE CHOOSE THE PROPER WAY ACCORDING TO THE TYPE OF THE WALL.
3. DO NOT USE TO LIFT PEOPLE OR ANIMALS.
4. NEVER OPERATE WHILE HAND(S) ARE NEAR MOVING PARTS.
5. DO NOT STAND UNDER LIFT.
Attention
1
1
1
Parts
2
3
4
5
6
7
8
1
1
NO.
Qty
Accessory
Upright Support
Top WallPlate
Bottom Wall Plate
The lower Shelf
The upper Shelf
Remote Control
Power Adapter
Connecting Cable
1
1
1
1
Suggested Installation Height
90'' - 96" (2300mm - 2400mm)
from the floor.
Note: The drawings here are for reference only, it may not accurately depict the real appearance.
Please contact customer service if there are missing parts or screws.
M8
Socket Wrench
(1 pc)
Button Cell
(1 pc)
Pistol-Grip Drill
90'' - 96" (2300mm - 2400mm)
D
Place the wall plate as
shown on the figure,
keeping the slot upside.
UP
1
2
3
4
5
6
8
7
B1
St8x70mm
Lag Bolts
(6 pcs)
B2
10x60mm
Plastic Expansion Bolts
(6 pcs)
B3
Washers
(6 pcs)
2
D
x1
B1
x4
B3
x4
B1
B3
0.39" (10 mm) 0.39" (10 mm)