Owner manual

Flexiock FLE Extended Roof Edge
Fully Adhered or Mechanically Attached Single-Ply Version
Warranty:
The entire roof system is covered under one warranty and inspected after the project is complete to
assure proper installation. The system is inspected after the project is complete to assure proper
installation. This ensures protection for the most vulnerable area of the roof against failure due to
extreme wind up lift pressures.
Testing:
• Tested per ANSI/SPRI ES-1 Standard to a design pressure of 190 Ibs./fE to comply with the
International Building Code,
• Factory Mutual 1-270 approved for wind up lift protection.
• Miami-Dade Approved (No. 08-0604.02 12/11/13) to comply with the “High Velocity Hurricane
Zone of the Florida Building Code”.
Standard Sizes:
Sizes range from 8 V2" up to 13" face heights to accommodate multiple nailers and coverage
requirements.
• 8 V2
• 10"
• 111/2"
• 13"
Anchor Bar Protection:
The patented, extmded aluminum anchor bar securely terminates the membrane. This provides protection unlike
any other manufactured or shop-fabricated edge. The anchor bar is readily available to dry-in the roof stmcture.
Available Materials:
Covers can be manufactured in .050" and .063" aluminum.
Splice Plates:
Interlocking, concealed splice plate design prevents splice plate migration under the fascia panels.This
creates a more aesthetically pleasing design compared to traditional cover plates or lap joints at the seams.
Watertight:
Its non-penetrating design eliminates the need for stripping-in or heat welding that is typical of
many other roof edge designs. Watertight integrity is not compromised by improper flashing
procedures, failed adhesives or lap sealants.
Competitively Priced:
The installed cost rivals even light gauge roof edge systems fabricated locally or in a roofer’s shop.
Efficient Design:
The product is provided in 12'-0" lengths with pre-punched holes for quicker installation and lower
labor costs. The fastening holes are slotted to allow for proper thermal movement of the materials
and ensure correct fastener placement and spacing.
Colors:
Choose among a wide range of standard colors and finishes that meet your job requirements. A 20
year Kynar 500® finish warranty is included on standard colors. Custom post-coated Kynar 500
colors are available with an included 10 year Kynar 500 finish warranty or a 20 year Kynar 500 finish
warranty is available upon request. Anodized finishes are also available, but are not warranted.
Custom Capabilities:
Radius and specially fabricated products are available to meet the unique needs of each project.
Accessories:
Factory fabricated miters, scuppers and drainage accessories provide a cleaner, more aesthetically
pleasing appearance. This eliminates the need for field fabrication, providing time and labor savings.
Also Included:
All anchor bar EPDM splice plates and fasteners are included and will arrive to the job site with the
product (sealant by others).
Reusable/Recyclable
Material:
When reroofing the anchor bar can be removed, cleaned and reinstalled at any time without
compromising its strength and appearance.
p: 800-969-0108
f: 610-916-9501
features & benefits
33