SDS

Cyanoacrylate Liquid Adhesive
Safety Data Sheet
according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
9/7/2021 (Revision date)
US - en
4/14
Emergency procedures
:
Evacuate unnecessary personnel. Eliminate ignition sources. Mark out the contaminated area
with signs and prevent access to unauthorized personnel. Stop the leak. Turn leaking containers
leak-side up to prevent the escape of liquid. Contain the spilled material by bunding.
6.2. Environmental precautions
Do not allow water (or moist air) contact with this material. Avoid release to the environment. Prevent entry to sewers and public waters. Notify
authorities if liquid enters sewers or public waters.
6.3. Methods and material for containment and cleaning up
For containment
:
Contain the spilled material by bunding.
Methods for cleaning up
:
Take up liquid spill into absorbent material, e.g.: sand, earth, vermiculite. (Do not use cloths;
rags or materials made from cellulose fibers). Place in an appropriate container and dispose of
the contaminated material at a licensed site. The product can be polymerized slowly with water
(10:1, adhesive : water). Cured product can then be disposed of in land-fill sites by licensed
contractors.
Other information
:
Dispose of materials or solid residues at an authorized site.
6.4. Reference to other sections
See Heading 8. Exposure controls and personal protection. For further information refer to section 13.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
:
Avoid contact of substance with water. Keep away from sources of ignition - No smoking. Do not
get in eyes, on skin, or on clothing. Ensure that there is a suitable ventilation system. Do not
handle in a confined space. Ambient humidity should be greater than 35% to minimise
discomfort.
Hygiene measures
:
Handle in accordance with good industrial hygiene and safety practice. Do not eat, drink or
smoke in areas where product is used. Wash hands and other exposed areas with mild soap and
water before eating, drinking or smoking and when leaving work.
7.2. Conditions for safe storage, including any incompatibilities
Technical measures
:
Keep in a cool, well-ventilated place away from heat. Keep away from water or moist air. Keep
out of direct sunlight.
Storage conditions
:
Keep container tightly closed. Store in a dry, well ventilated place away from sources of heat,
ignition and direct sunlight. Store away from the following materials: Amines.
Incompatible products
:
Amines. Oxidising agents. Alkali metals. Water. Strong bases. Strong acids. alcohols.
Incompatible materials
:
Sources of ignition. Direct sunlight. Water, humidity.
Storage temperature
:
2 – 25 °C
Storage area
:
For optimum shelf-life, it is recommended to keep the product in a refrigerated storage area.
Packaging materials
:
Store always product in container of same material as original container.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
No additional information available
8.2. Appropriate engineering controls
Appropriate engineering controls
:
Ensure all national/local regulations are observed. Avoid all unnecessary exposure. Provide
adequate general and local exhaust ventilation.