Use and Care Manual

REMOVAL & STORAGE

REMOVING FROM SURFACES

All of our Flood Protection products have been designed to be

easily removed.

| ALL PRODUCTS

1. Starting at a corner, use your thumb or a cloth to peel the product

until there is enough to grab and pull away from surface using

your hands.

2. If it doesn’t remove in one piece, restart the process on

another section.

3. Any remaining residue can be cleaned using a paper towel or rag

with denatured alcohol.

| SMALL & HARD-TO-REACH AREAS

1. Use needle-nose pliers to grab one corner of the product and

continue to pull product until it is within grasp.

2. Pull o the remainder of product by hand.

STORAGE

All remaining and/or unused Flood Protection products should be

stored in a cool and dry environment. They should not be exposed to

temperatures over 120 degrees. Below are some specic tips to help

you prolong the life of your products:

| FLEX PASTE

FLOOD PROTECTION

CARTRIDGE: Leave a small bead of Paste at the tip of the nozzle to create an airtight plug.

Remove plug when ready to reuse.

SLEEVE: Fold the empty portion of packaging down to the remaining material and secure with a

clamp or tie.

| FLEX SEAL LIQUID

FLOOD PROTECTION

JAR: Replace and secure the lid tightly.

CAN: Replace the lid and use a rubber mallet to seal the can. If using a hammer, take special care

not to damage the can.

| FLEX TAPE

FLOOD PROTECTION

Simply place Tape in a sealed plastic storage bag.

| FLEX SEAL

SPRAY FLOOD PROTECTION

After use and before storing, turn can upside down and spray a few seconds to clear the nozzle to

prevent clogging. Do this outdoors.