Use and Care Manual

23
Clean area to be sealed. Measure the opening. Cut a piece of plywood
larger than opening.
Remove an even amount of
Paste from tray.
Apply Paste generously
around opening.
Press plywood in place
over opening.
Paste should squeeze out
between the plywood and wall.
Hold or brace plywood in place a
few minutes.
Use gloved nger or Flex Gap
Filler tool to push Paste into
seams and smooth out.
Apply additional overlapping
coats of Paste, if needed.
Brush Liquid on top of entire
piece of plywood.
Brush an overlapping coat of
Liquid on top of Paste and where
it meets wall.
4
7
10
21
5
8
11
3
6
9
12