Specification
SAFETY DATA SHEET
Flex Seal Liquid®
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above. Use local exhaust ventilation to control airborne vapor. Ensure
eyewash/safety shower stations are available near areas where this product is used.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with OSHA
regulations found in 29 CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or standards of EU member
states (including EN 149 for respiratory PPE, and EN 166 for face/eye protection), and those of Japan. Please reference applicable
regulations and standards for relevant details
.
RESPIRATORY PROTECTION: Maintain airborne contaminant concentrations below guidelines listed above, if applicable.
If necessary, use only respiratory protection authorized in the U.S. Federal OSHA Respiratory Protection Standard (29
CFR 1910.134), equivalent U.S. State standards, Canadian CSA Standard Z94.4-93, the European Standard EN149, or
EU member states.
EYE PROTECTION: Safety glasses or chemical goggles as appropriate to prevent eye contact. If necessary, refer to
U.S. OSHA 29 CFR 1910.133 or appropriate Canadian Standards.
HAND PROTECTION: Use chemical resistant gloves to prevent skin contact. If necessary, refer to U.S. OSHA 29 CFR
1910.138 or appropriate Standards of Canada.
BODY PROTECTION: Use body protection appropriate to prevent contact (e.g. lab coat, overalls). If necessary, refer to
appropriate Standards of Canada, or appropriate Standards of the EU, Australian Standards, or relevant Japanese
Standards.
SECTION 9 - PHYSICAL and CHEMICAL PROPERTIES
PHYSICAL STATE:
Liquid
APPEARANCE & ODOR:
Viscous liquid in various colors including white, tan, light gray
black, and clear with a slight odor.
ODOR THRESHOLD (PPM):
Not Available
VAPOR PRESSURE (mmHg):
Not Available
VAPOR DENSITY:
Not Available
EVAPORATION RATE (nBuAc = 1):
Not Available
BOILING POINT (C°):
Not Available
FREEZING POINT (C°):
Not Available
pH:
Not Available
SPECIFIC GRAVITY 20°C: (WATER =1)
Not Available
SOLUBILITY IN WATER (%)
Not Available
STABILITY: Product is stable
DECOMPOSITION PRODUCTS: When heated to decomposition this product produces noxious gases such as CO,
CO
2
, and others.
MATERIALS WITH WHICH SUBSTANCE IS INCOMPATIBLE: None known
HAZARDOUS POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID: Heat and sources of ignition.
SECTION 11 - TOXICOLOGICAL INFORMATION
TOXICITY DATA: Toxicity data is available for this product:
CAS# 13463-67-7 LD50 Acute Oral
>10000 mg/kg
Rat
CAS# 112945-52-5 LD50 Acute Oral
3160 mg/kg
Rat
CAS# 556-67-2 LD50 Inhalation
>12.7 mg/kg/4Hr
Rat
CAS# 556-67-2 LD50 Acute Oral
1540 mg/kg
Rat
CAS# 556-67-2 LD50 Acute Dermal
>2400 mg/kg
Rat
SECTION 10 – STABILITY and REACTIVITY
Currently, International exposure limits are not established for the components of this product. Please
check with
competent authority in each country for the most recent limits in place.
Page 5 of 8