User Manual
Table Of Contents
- Introduction
- Includes
- REQUIRES
- SPECIFICATIONS
- Specifications
- Optional Items
- Completion Items
- Replacement Parts Listing
- BATTERY CHARGING GUIDELINES
- IMPORTANT INFORMATION REGARDING WARRANTY
- SAFETY WARNINGS AND PRECAUTIONS
- LOW VOLTAGE CUTOFF
- MAIN LANDING GEAR INSTALLATION
- TAILWHEEL INSTALLATION
- Vertical STABILIZER INSTALLATION
- HORIZONTAL STABILIZER INSTALLATION
- MAIN WING INSTALLATION
- AURA 8 AFCS
- TRANSMITTER SETUP
- RECEIVER INSTALLATION
- SERVO CONNECTIONS
- Connecting Your Receiver to Aura
- Connecting Your Receiver to Aura (CONTINUED)
- CONNECTING BATTERY/ARMING ESC
- ESC Throttle Calibration
- CONNECTING A BATTERY TO THE LED CONTROLLER (NIGHT VERSION ONLY)
- LINKAGE SETUP
- RUDDER AND ELEVATOR LINKAGE INSTALLATION
- CONTROL DIRECTION TEST
- Aura Sensor DIRECTION TEST
- Prop Adapter, PROPELLER and SPINNER INSTALLATION
- BATTERY INSTALLATION
- CENTER OF GRAVITY
- PRE-FLIGHT CHECKLIST
- AMA Safety Code
- FLYING YOUR QQ Yak 55 10E Super PNP
- AIRFRAME REPAIRS
- REPLACING SERVOS
- AIRCRAFT TROUBLESHOOTING GUIDE
- LIMITED WARRANTY
7
TAILWHEEL INSTALLATION
Required Tools and Fasteners: #1 Phillips Screwdriver (2) M2x8 self-tapping Phillips head cap screws
1. Locate the vertical fin assembly, tail wheel and tail wheel retaining plate. Insert the tail wheel assembly into the bottom of the
rudder, being sure to orient it so that the tail wheel wire angles towards the tail as the wire moves away from the fuselage.
2. Insert the retaining plate into the cavity on the bottom of the rudder. Use a #1 Phillips screwdriver and the two M2x8 self-
tapping screws to secure it in place.
(QTY 2)