User Manual
Table Of Contents
- Introduction
- Includes
- REQUIRES
- SPECIFICATIONS
- Specifications
- Optional Items
- Completion Items
- Replacement Parts Listing
- BATTERY CHARGING GUIDELINES
- IMPORTANT INFORMATION REGARDING WARRANTY
- SAFETY WARNINGS AND PRECAUTIONS
- LOW VOLTAGE CUTOFF
- MAIN LANDING GEAR INSTALLATION
- TAILWHEEL INSTALLATION
- Vertical STABILIZER INSTALLATION
- HORIZONTAL STABILIZER INSTALLATION
- MAIN WING INSTALLATION
- AURA 8 AFCS
- TRANSMITTER SETUP
- RECEIVER INSTALLATION
- SERVO CONNECTIONS
- Connecting Your Receiver to Aura
- Connecting Your Receiver to Aura (CONTINUED)
- CONNECTING BATTERY/ARMING ESC
- ESC Throttle Calibration
- CONNECTING A BATTERY TO THE LED CONTROLLER (NIGHT VERSION ONLY)
- LINKAGE SETUP
- RUDDER AND ELEVATOR LINKAGE INSTALLATION
- CONTROL DIRECTION TEST
- Aura Sensor DIRECTION TEST
- Prop Adapter, PROPELLER and SPINNER INSTALLATION
- BATTERY INSTALLATION
- CENTER OF GRAVITY
- PRE-FLIGHT CHECKLIST
- AMA Safety Code
- FLYING YOUR QQ Yak 55 10E Super PNP
- AIRFRAME REPAIRS
- REPLACING SERVOS
- AIRCRAFT TROUBLESHOOTING GUIDE
- LIMITED WARRANTY
6
4. Locate the wheel and axle assembly. Remove the nut from the axle and insert the axle into the landing gear bracket.
5. Using needle nose pliers to hold the axle firmly, use a 7mm wrench to tighten the nut to the wheel and axle assembly.
6. Fasten the outside of the wheel pants using a #2 Phillips screwdriver and two M3x10 machine screws.