User Manual
Table Of Contents
- Introduction
- Includes
- REQUIRES
- SPECIFICATIONS
- Specifications
- Optional Items
- Completion Items
- Replacement Parts Listing
- BATTERY CHARGING GUIDELINES
- IMPORTANT INFORMATION REGARDING WARRANTY
- SAFETY WARNINGS AND PRECAUTIONS
- LOW VOLTAGE CUTOFF
- MAIN LANDING GEAR INSTALLATION
- TAILWHEEL INSTALLATION
- Vertical STABILIZER INSTALLATION
- HORIZONTAL STABILIZER INSTALLATION
- MAIN WING INSTALLATION
- AURA 8 AFCS
- TRANSMITTER SETUP
- RECEIVER INSTALLATION
- SERVO CONNECTIONS
- Connecting Your Receiver to Aura
- Connecting Your Receiver to Aura (CONTINUED)
- CONNECTING BATTERY/ARMING ESC
- ESC Throttle Calibration
- CONNECTING A BATTERY TO THE LED CONTROLLER (NIGHT VERSION ONLY)
- LINKAGE SETUP
- RUDDER AND ELEVATOR LINKAGE INSTALLATION
- CONTROL DIRECTION TEST
- Aura Sensor DIRECTION TEST
- Prop Adapter, PROPELLER and SPINNER INSTALLATION
- BATTERY INSTALLATION
- CENTER OF GRAVITY
- PRE-FLIGHT CHECKLIST
- AMA Safety Code
- FLYING YOUR QQ Yak 55 10E Super PNP
- AIRFRAME REPAIRS
- REPLACING SERVOS
- AIRCRAFT TROUBLESHOOTING GUIDE
- LIMITED WARRANTY
5
MAIN LANDING GEAR INSTALLATION
Required Tools and Fasteners: #2 Phillips Screwdriver (2) M3x14 Phillips Head Machine Screw
7mm Wrench (2) M3x10 Phillips Head Machine Screw
Needle Nose Pliers (4) M3x10 Phillips Head Self-Tapping Screw
7mm Open Wrench (optional) Blue Thread Lock
Adjustable Wrench (optional)
1. Locate the landing gear. Using blue thread lock, install the landing gear on the fuselage using a #2 Phillips screwdriver and two M3x15 screws.
Mount the landing gear so that they sweep toward the nose of the aircraft, as shown in the diagram.
2. Place the landing gear cover over the landing gear as shown in the picture and secure with clear tape.
3. Locate the landing gear wheel pants. Place the inside half of the wheel pant against the outside of landing gear leg. Use a #2 Phillips
screwdriver and a M3x10 machine screw to secure the wheel pant half in place. Be sure the wheel pants are oriented in the proper direction.
Nose
Tail
(QTY 4)
(QTY 2)
(QTY 2)