User Manual

19
PROP ADAPTER, PROPELLER AND SPINNER INSTALLATION
Required Tools and Fasteners: 2mm Hex Driver (4) M2.5 x 8 socket head machine screws
Adjustable Wrench (1) M3 x 6 button head machine screw
Blue Thread Lock
1. Place the prop adapter on the motor bell housing checking that the holes in the prop adapter line up with the holes in the motor bell
housing. Using the 2mm hex driver, secure the prop adapter to the motor bell housing using the M2.5 x 8 socket head machine screws.
Apply a small amount of blue thread lock to the screws and ensure that they are tightened fully.
2. Install the propeller on the prop adapter with the convex surface facing forward. The printing is on the front face of the prop and should
orient forward.
3. Slide the prop washer on the prop adapter with the widest face aft, followed by the propeller nut. Using an adjustable wrench, tighten the
propeller nut fully.
4. Slide the spinner over the prop and prop shaft and secure it using a 2mm hex driver and the M3 X 6mm machine screw.
NOTICE
Spin the motor over by hand to ensure that the prop and spinner spin smoothly and true after installation.
(QTY 4)
(QTY 1)