User Manual
Table Of Contents
- Introduction
- Includes
- REQUIRES
- SPECIFICATIONS
- Specifications
- Optional Items
- Completion Items
- Replacement Parts Listing
- BATTERY CHARGING GUIDELINES
- IMPORTANT INFORMATION REGARDING WARRANTY
- SAFETY WARNINGS AND PRECAUTIONS
- LOW VOLTAGE CUTOFF
- MAIN LANDING GEAR INSTALLATION
- TAILWHEEL INSTALLATION
- Vertical STABILIZER INSTALLATION
- HORIZONTAL STABILIZER INSTALLATION
- MAIN WING INSTALLATION
- AURA 8 AFCS
- TRANSMITTER SETUP
- RECEIVER INSTALLATION
- SERVO CONNECTIONS
- Connecting Your Receiver to Aura
- Connecting Your Receiver to Aura (CONTINUED)
- CONNECTING BATTERY/ARMING ESC
- ESC Throttle Calibration
- CONNECTING A BATTERY TO THE LED CONTROLLER (NIGHT VERSION ONLY)
- LINKAGE SETUP
- RUDDER AND ELEVATOR LINKAGE INSTALLATION
- CONTROL DIRECTION TEST
- Aura Sensor DIRECTION TEST
- Prop Adapter, PROPELLER and SPINNER INSTALLATION
- BATTERY INSTALLATION
- CENTER OF GRAVITY
- PRE-FLIGHT CHECKLIST
- AMA Safety Code
- FLYING YOUR QQ Yak 55 10E Super PNP
- AIRFRAME REPAIRS
- REPLACING SERVOS
- AIRCRAFT TROUBLESHOOTING GUIDE
- LIMITED WARRANTY
17
CONTROL DIRECTION TEST
Refer to the chart below to determine the proper control surface directions.
If controls are reversed, DO NOT REVERSE CONTROLS IN YOUR TRANSMITTER OR IN THE AURA CONFIG TOOL. Email us at
support@flexinnovations.com for corrective action. Note that BOTH the Transmitter Control Direction Test AND the Flight Controller
Sensor Direction Test MUST BE PASSED! IF EITHER ONE DOES NOT PASS, DO NOT FLY!
NOTE: There is pre-configured rudder to aileron and rudder to elevator mixing programmed into the Aura. Simultaneous
movement of these control surfaces with rudder input is intentional and completely NORMAL.
Transmitter
Command
Proper Control
Surface Deflection
Stick Left
Stick Right
Stick Forward
Stick Aft
Stick Left
Stick Right
AILERON
ELEVATOR
RUDDER