User Manual

10
MAIN WING INSTALLATION
Required Tools and Fasteners: Medium CA Adhesive M3x18 Thumb Machine Screw (2)
1. Find the wings and the side force generators. The rear of the side-force generator is the wide end and will line up with the ailerons.
2. Test fit the side-force generators into the wing-tips and make any adjustments as necessary. Using medium CA adhesive bond the side-force
generators to the corresponding wing-tip. Wait for the adhesive to cure before proceeding to the next step.
3. Remove the battery hatch from the fuselage by pulling the spring-loaded latch tab back to release it. Lift the hatch away from the fuselage,
starting at the front..
4. Insert the main wing tube into the fuselage and roughly center.
5. Slide the left and right wing panels onto the tube.
6. Fully seat the wing into the fuselage while being careful to align the wing mounting tab with the slot in the fuselage. Be sure to avoid
pinching any wires during this process.
7. Secure each wing to the fuselage using an M3x18 thumb screw on the inside of the fuselage (you can use a #2 Phillips screwdriver if
desired).
8. Connect the servo leads from the ailerons in the wings into the Aura, the left aileron goes into port S2 and the right aileron goes into the
port S3.
9. If you have a night version, connect the wing JST to any available connector on the LED controller.