User Manual
Table Of Contents
- Introduction
- Includes
- REQUIRES
- SPECIFICATIONS
- Specifications
- Optional Items
- Completion Items
- Replacement Parts Listing
- BATTERY CHARGING GUIDELINES
- IMPORTANT INFORMATION REGARDING WARRANTY
- SAFETY WARNINGS AND PRECAUTIONS
- LOW VOLTAGE CUTOFF
- MAIN LANDING GEAR INSTALLATION
- TAILWHEEL INSTALLATION
- Vertical STABILIZER INSTALLATION
- HORIZONTAL STABILIZER INSTALLATION
- MAIN WING INSTALLATION
- AURA 8 AFCS
- TRANSMITTER SETUP
- RECEIVER INSTALLATION
- SERVO CONNECTIONS
- Connecting Your Receiver to Aura
- Connecting Your Receiver to Aura (CONTINUED)
- CONNECTING BATTERY/ARMING ESC
- ESC Throttle Calibration
- CONNECTING A BATTERY TO THE LED CONTROLLER (NIGHT VERSION ONLY)
- LINKAGE SETUP
- RUDDER AND ELEVATOR LINKAGE INSTALLATION
- CONTROL DIRECTION TEST
- Aura Sensor DIRECTION TEST
- Prop Adapter, PROPELLER and SPINNER INSTALLATION
- BATTERY INSTALLATION
- CENTER OF GRAVITY
- PRE-FLIGHT CHECKLIST
- AMA Safety Code
- FLYING YOUR QQ Yak 55 10E Super PNP
- AIRFRAME REPAIRS
- REPLACING SERVOS
- AIRCRAFT TROUBLESHOOTING GUIDE
- LIMITED WARRANTY
9
HORIZONTAL STABILIZER INSTALLATION
Required Tools and Fasteners: #2 Phillips Screwdriver (2) M3x10 Phillips Head Self-Tapping Screw
1. Insert the horizontal stabilizer tube into the fuselage and roughly center.
2. Slide the left and right stabilizer halves onto the tube. Ensure that the control horn orients towards the belly of the airplane.
3. If you have the night version connect the LED lights in the horizontal stabilizers using the provided connectors.
4. Ensure and that the elevator joiner tabs are properly indexed and bring the two halves together. Do not force the stabilizer into place.
5. Use a #2 Phillips screwdriver and the two M3x10 self-tapping screws to secure each stabilizer half in place.
(QTY 2)