FlexJet G2 90mm EDF Super PNP Manual

INNOVATIONS
TM
©2018 Flex Innovations, LLC.
Premier Aircraft™, Potenza™, and Top Value RC™ are trademarks or registered trademarks of Flex Innovations, LLC.
DSM®, DSM2™, and DSMX™ are trademarks or registered trademarks of Horizon Hobby LLC
Futaba™ is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan.
Jeti™, UDI, and Jeti Model are trademarks or registered trademarks of Jelen, Ing. Stanislav of Czech Republic
Hitec is a trademark or registered trademark of Hitec RCD USA Inc.
Graupner HoTT® is a registered trademark of Graupner Co., Ltd.
Version 1.0
Created 12/2017
w w w . f l e x i n n o v a t i o n s . c o m
Elevator Trim Gauges
Stab Center
Front
Rear
Top
Bottom
Right Stab
1"
1"
Align with Panel Line
Left Stab
Front
Rear
Bottom
Top
Stab Center
1"
1"
Align with Panel Line
Cut-out the elevator trim gauges by cutting around the thick solid line. Do not cut through the center line.
Fold the elevator trim gauges at the dashed lines.
Verify the elevator trim gauges are printed at proper size by measuring the 1 inch vertical and horizontal scale.
Please reference page 10, step 3 for use with FlexJet
1.
2.
3.
4.