FlexJet G2 90mm EDF Super PNP Manual

EXPERT FLIGHT MODE 3 TRANSMITTER CONTROL DIRECTION TEST

Stick

Movement

Proper Control

Surface Deflection

AILERONELEVATOR

RUDDER

Stick Left

Stick Right

Stick Aft

Stick Forward

Stick Left

Stick Right

Refer to the chart below to determine the proper control surface directions relative to transmitter stick input.

Note: There is pre-configured rudder to aileron and rudder to elevator mixing programmed into the Aura. If you see elevator or

ailerons move with rudder stick input, this function is intentional and completely NORMAL.

If controls are reversed, DO NOT REVERSE CONTROLS IN THE TRANSMITTER OR THE AURA CONFIG TOOL. Email us at

support@flexinnovations.com for corrective action. Please note, that BOTH the Transmitter Control Direction Test AND the

Flight Controller Sensor Direction Test (page 18) MUST BOTH BE PASSED! IF ONE DOES NOT PASS, DO NOT FLY!

Trailing Edge

Perform the following Transmitter control test, after installing (via quick set or Aura Config Tool) Aura 8 Expert configuration. Please

note, this control test is only for Mode 3, to test modes 1 and 2 please reference page 17. Please note,Control Surface deflection has

been exaggerated for clarity.

Trailing Edge