FlexJet G2 90mm EDF Super PNP Manual

Wing Installation
Locate the four carbon fiber wing tubes. Insert a short tube into each wing panel near the leading edge and a long tube into each
wing panel near the trailing edge of the wing.
Orient the servos toward the bottom of the fuselage and slide the left and right wing panels half-way onto the fuselage.
Connect the aileron servo lead to its respective extension in the fuselage.
Fully seat the wing panels into the fuselage, while being careful to align the wing mounting tab with the slot in the fuselage. Be sure to
avoid pinching wires during this process.
Using a #1 phillips screwdriver, secure each wing panel to the fuselage with a M3x10 phillips head self-tapping screw. Avoid over-
tightening the screw, and do NOT use blue thread locker on this connection.
Power on the radio system. Check the aileron trim by comparing the trailing edge of the aileron relative to the trailing edge of the wing.
If adjustment is needed, remove the clevis from the control horn, and turn the clevis. Re-attach the clevis to the control horn and
inspect the mechanical trim of the aileron. Repeat this step until the aileron is flush with the trailing edge of the wing.
Once satisfied with the mechanical trim of the aileron, apply a drop of blue thread locker at the point where the clevis and control
linkage meet.
1.
2.
3.
5.
7.
12
Required Tools and Fasteners:
#1 Phillips Screwdriver
Blue Thread Locker
(2) M3x10 Phillips Head Self-Tapping Screws
4.
6.
8.
*Apply blue thread locker*