QQ CAP 232EX 60E Super PNP Manual

MAIN LANDING GEAR INSTALLATION
Required Tools and Fasteners:
Locate the landing gear, axle assemblies, wheel pants, and M4 nuts and washers.
Use a Phillips screwdriver to remove the M3x12 self-tapping screws from the wheel pants, and separate the wheel pant halves from
one another.
Remove the M4 nut and washer from the axle assembly (if required). Slide the axle through the landing gear, and place an M4 washer
over the exposed threads of the axle. Secure the axle in place using an M4 lock nut, and two 7mm wrenches. Tighten fully.
Install the inside-half of the wheel pant to the landing gear using an M3x10 Phillips head machine screw, and blue thread lock. If you
wish to leave the wheel pants off of the aircraft, you can skip this step as well as step 5.
Re-install the outside half of the wheel pant to the inner half using the M3x12 self-tapping screws removed in step 2.
1.
2.
3.
4.
5.
7mm Wrench (2)
#1 Phillips Screwdriver
M4 Washer (2)
M4 Lock Nut (2)
M3x10 Phillips Head Machine Screw (2)
M3x15 Phillips Head Machine Screw (4)
6
Axle/Wheel Assembly
Landing Gear
Wheel Pants
Blue Thread Lock
Medium CA
x2
x2