QQ CAP 232EX 60E Super PNP Manual

RUDDER INSTALLATION

Required Tools and Fasteners:

Medium CA (or 5-15 minute epoxy)

#1 Phillips Screwdriver

3 - M3x10 Phillips Head Self-Tapping Screw

1 - M3x10 Phillips Washer Head Self-Tapping Screw

The rudder comes pre-hinged to a small section of vertical fin. Test fit the rudder and fin section onto the fuselage and remove it

from the fuselage once fit is confirmed.

Lay the fuselage on its side, and using medium CA or epoxy (foam-safe is not required), apply an adequate amount to the

fuselage. Press the rudder and vertical fin section into the fuselage, being sure to wipe away any excess glue.

Secure the lower plastic hinge in place by threading an M3x10 phillips washer head self-tapping screw through the bottom of the

plastic hinge in the fuselage. Do not fully tighten, as you can cause the rudder to bind. A small amount of play is needed here.

Allow time for the CA to dry, and once dry, check for proper rudder movement. Be sure the rudder moves freely with little to no

binding.

Press the tailwheel wire into the plate on the bottom of the rudder. Be sure to orient the tailwheel such that it angles aft as it moves

away from the fuselage. Lay the tailwheel plate over the wire, and secure it in place with three M3x10 phillips head self-tapping

screws.