QQ CAP 232EX 60E Super PNP Manual

ADVANCED QQ CAP 232EX AURA CONFIGURATION
21
The Aura 8 installed in the QQ Cap 232EX is equipped with two possible Aura configurations - Stock and Expert. These may be
accessed WITHOUT THE USE OF A WINDOWS-BASED PC OR TABLET by using the Aura Quick Set feature. The "Expert" version
offers three flight modes: Sport, High Speed 3D and Slow Speed 3D.
NOTICE
The "Expert" flight modes cannot be configured by Quick Set when using PWM servo connections to Aura. If you are a PWM
user, and wish to configure the Expert program, you must do so through the New Aura Config File Wizard in the Aura Config
Tool (Windows-based Aura programming application)
Mode 1 - Sport Mode 2 - High Speed 3D Mode 3 - Low Speed 3D
For sport or precision aerobatics.
Rates are low, expo adjusted for smooth
flight.
Gains are set low.
For high speed flying (full throttle) at high
rate. Ideal for tumbling and high energy
aerobatics.
Rates are high, expo adjusted high for
smooth flight.
Gains are set low.
For slow speed "high-alpha" flight. Ideal for
harriers, hovering, and other slow speed
flight.
Rates are at max, expo adjusted high for
smooth flight.
Gains are set high.
This mode should not be used to fly the
airplane at medium to high air speeds.
Control surface oscillation will occur
at high speed in this mode.
The expert program is gyro-enabled in all 3 flight modes. If you wish to use a secondary switch to be able to turn the Aura off, we
recommend using the Wizard in the Aura Config Tool, and setting up a Gyro Kill switch.
1.
2.
3.
4.
5.
6.
7.
8..
Make sure all power is removed from the QQ Cap 232EX. Be sure to remove the propeller for safety.
Turn on your transmitter. Ensure you are on the correct model memory.
Remove the servo lead that is in Aura Port S2.
Insert a bind plug into Aura Port S2.
Power the QQ Cap 232EX by plugging a battery into the ESC. The LEDs on the Aura will repeatedly double flash orange. This confirms
you have entered Quick Set mode. The Green LED may be flashing, or solid. More information regarding the green LED is below.
Use the Gear (CH5) switch (assigned earlier for Aura Flight Modes) to select the Expert or Stock Aura configurations.
If the green LED on the Aura is SOLID, the Aura is set to use the STOCK configuration.
If the green LED on the Aura is FLASHING, the Aura is set to use the EXPERT configuration.
Once you have selected your configuration, simply remove the bind plug from S2. All LEDs on Aura will be on while Aura is saving the
settings. Once saved, the Aura will go back to its previous LED configuration from step 6. Power off the airplane and Aura, and replace
the servo lead back into Aura Port S2.
Verify that all controls function, and that both the transmitter direction test and Aura sensor direction test pass. Familiarize yourself with
the new flight modes and their relative switch positions, and enjoy flying with your new flight modes!
For more information on how to access the Expert program via the Aura Config Tool, please visit:
wiki.flexinnovations.com/QQCap232EX