QQ CAP 232EX 60E Super PNP Manual

LINKAGE AND HORIZONTAL STABILIZER INSTALLATION
12
Required Tools and Fasteners:
Locate the rudder and elevator pushrod assemblies. Note that both pushrods and servo arms are the same length, but they are
connected to different locations in the servo arms. Reference the servo arm chart at the bottom of the page for more details.
Power on your transmitter, and move your Gear (CH5) switch to Mode 1 (Gyro Off). Power on the airplane, and confirm the Aura is in
Mode 1 by moving the airplane quickly, and verifying that you get no gyro controlled servo movement.
Install the servo arm perpendicular to the servo case, being sure to orient the servo arm torwards the bottom of the fuselage. Apply blue
thread lock to the M3x6 phillips head machine screw, and secure the servo arm in place. Verify that the M2x10 phillips head machine
screw and M2 lock nut that attaches the ball link to the servo arm is secure.
Insert the horizontal stabilizer tube into the fuselage, and roughly center.
Slide the left and right sides of the horizontal stabilizer onto the tube. Ensure the control horn orients to the bottom of the fuselage, and
that the elevator joiner tabs are indexed properly. Do not force the stabilizer into place.
Apply 4 pieces of clear tape to the joint between the stabiizer and the plastic mounts. Be sure to apply tape to both the top and bottom
of the stabilizer halves.
1.
2.
3.
4.
5.
6.
Elevator and Rudder Pushrod Assemblies
M2x10 Phillips Head Machine Screw (2)
M2 Flat Washer (2)
M2 Lock Nut (2)
M3x6 Phillips Head Machine Screw (2)
#1 Phillips Screwdriver
#0 Phillips Screwdriver
Needle-Nosed Pliers (or Hemostats)
Blue Thread Lock
*Note: Linkage location shown is not the proper
location in the servo arm. Reference page 13 for
proper linkage locations.
Servo Arms
Elevator Rudder