Getting Started Guide

6 | Rev 0.5
CONNECTOR B (10-PIN FCI) CABLE COLOR TABLE :
Pin no. Cable definition Color
1 Ground Black
2 12/24/48V Power in Red
3 CANH (2.0B or FD) / ISO-15765 or J1939 Gray/Green
4 CANL (2.0B or FD) / ISO-15765 or J1939 Gray/Yellow
5 RS-232 #1 TxD Orange
6 RS-232 #1 RxD Pink
7 12V Out (2.5W) Purple
8 Digital Input #1_ignition (Programable Bias) White/Yellow
9 Digital Input #2 (Programable Bias) White/Gray
10 Digital Input #3 (Programable Bias) White/Green
*Chassis Ground Connection
1. Connect the device’s ground wire (black) to vehicle’s chassis.
2. For a solid connection, use a ring tongue terminal connector, star washer and a self-tapping screw.
3. Do not ground under existing bolts that hold brackets or panels in place.
After wiring installation is complete, turn on the device by holding the power button for 2-4s until the power LED
illuminates. You may see the device progress through a series of start-up steps, indicated by different LEDs as
detailed below. This process typically takes 2 minutes but can take up to 20 minutes on first power-up.
Depending on GPS and cellular signal, a typical sequence may proceed as follows:
1) Power LED-Power on (~30s).
2) Data LED medium flashing - Retrieving network time.
3) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location.
4) GPS LED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy.
5) GPS LED off.
6) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location.
7) GPS LED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy.
8) Data LED medium flashing - Device is searching for a cellular network.
9) Data LED rapid flashing - Device is connected to a cellular network and transmitting/receiving data.
10) Data LED off (device has finished start-up sequence and is operational).
Warranty Information
WARNING: Any disassembly and reassembly will compromise sealing and void the warranty. For optimal
performance, please do not disassemble or modify this product.