Getting Started Guide

4 | Rev 0.5
Record Device Information
Record the following information for activation and for your records:
» Device Product Name (see image of label below)
» Device Model Name (see image of label below)
» Device SN/IMEI (see image of label below)
» Device ICC ID (if available)
Pre-installation
*Recommended tools and supplies for installation
Basic Tools:
• Wire Strippers
• Connector Crimping Tool
• Panel Removal Tool
• Digital Multimeter (DMM)
• T-10S Torx Screwdriver
Basic Supplies:
• Ring Terminals
• Cable Zip-Ties
• Electrical Tape
• Spare Fuses (3 Amp)
• Self-Tapping Screws
Review this installation manual to become familiar with all installation procedures and electrical wiring requirements
prior to starting the installation. This installation guide has been prepared to provide you with details necessary to
complete the device installation.
Use of proper tools and testing equipment is required. Never use a grounding style test light. Use only a Digital Multi
Meter (DMM) to test wires in the vehicle.
Ensure that all wiring is protected from heat sources and sharp metal edges and is routed in such manner that it will
not get damaged or pinched when vehicle components and trim are reinstalled. Run new wiring along factory
harnesses and secure with quality cable zip-ties. Be sure to leave a “service loop” near the device, enough slack in
the wiring to allow working room and strain relief.
The device is NOT waterproof, never mount the device in the engine compartment. When mounting the device,
determine best possible location under the dash and make sure that the device will be securely attached using self-