Getting Started Guide Advanced telematics tracker Made by: flex Model: HT800-LM0QGL/ HT800-LM0Q-TE/ HT801-LM0Q-GL/ HT801LM0Q-TE 0 | Rev 0.
Rugged Advanced Telematics Tracker Safety Warnings Read this complete guide before installing the device. This device contains a Lithium Ion battery. If these guidelines are not followed, the battery may experience a shortened life span or may present a risk of damage to the device, fire and/or bodily injury. — Do not penetrate the battery or device with a nail etc., nor make a hole in the battery.
Multi-function Button The device has multi-functions in one button. It can be used to power on and off the device, force a manual sync with the device management server and to check for any error conditions.
» If the device was able to connect to the network and successfully received its unlock command, the power LED will now emit 3 sets of 4 medium flashes. Once unlocked, the user can: • Power down the device • Connect to Bluetooth (if the device is capable) • Connect over serial port to configure the device (if available) » Note: The device will stay in the unlocked state for 30 minutes after which it will lock itself again.
Record Device Information Record the following information for activation and for your records: » Device Product Name (see image of label below) » Device Model Name (see image of label below) » Device SN/IMEI (see image of label below) » Device ICC ID (if available) Pre-installation *Recommended tools and supplies for installation Basic Tools: • Wire Strippers • Connector Crimping Tool • Panel Removal Tool • Digital Multimeter (DMM) • T-10S Torx Screwdriver Basic Supplies: • Ring Terminals • Cable Z
The device is NOT waterproof, never mount the device in the engine compartment. When mounting the device, determine best possible location under the dash and make sure that the device will be securely attached using selftapping screws or cable zip-ties. Do not force or jam the device into tight places instead of mounting it. When mounting the Device, do not obstruct any serviceable areas such as fuse boxes, etc.
CONNECTOR B (19-PIN BAYONET) CABLE COLOR TABLE: Pin no. Cable definition Color 1 Ground & USB Host: Gnd Black 2 USB Host: 5VBUS out; 500mA Brown 3 USB Host: D+ White/Pink 4 USB Host: D- Brown/Pink 5 USB OTG ID pin Brown/Blue 6 RS-232 #2 TxD Gray/pink 7 RS-232 #2 RxD Gray/brown 8 CANH (2.0B) / ISO-15765 or J1939 Blue 9 CANL (2.
5) GPS LED off. 6) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location. 7) GPS LED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy. 8) Data LED medium flashing - Device is searching for a cellular network. 9) Data LED rapid flashing - Device is connected to a cellular network and transmitting/receiving data. 10) Data LED off (device has finished start-up sequence and is operational).
l'antenne de cet appareil ettoutes les personnes. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numeriquede la classe B est conforme a la norme NMB-003 du Canada. CE Warning statements Hereby, Flex Industrial, Ltd. declares that the radio equipment type HT800/HT801 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: Suppliers Name: Flex Industrial, Ltd.