Getting Started Guide

6|Rev.0.1

2. For a solid connection, use a ring tongue terminal connector, star washer and a self-tapping screw.
3. Do not ground under existing bolts that hold brackets or panels in place.
After wiring installation is complete, turn on the device by holding the power button for 2-4s until the power LED
illuminates. You may see the device progress through a series of start-up steps, indicated by different LEDs as
detailed below.This process typically takes 2 minutes but can take up to 20 minutes on first power-up.
Depending on GPS and cellular signal, a typical sequence may proceed as follows:
1) Power LED-Power on (~30s).
2) Data LEDmedium flashing- Retrieving network time.
3) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location.
4) GPSLED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy.
5) GPS LED off.
6) GPS LED slow flashing - Device GPS Receiver is on and attempting to get the device location.
7) GPS LED rapid flashing - GPS receiver has acquired a fix but is waiting for location within target accuracy.
8) Data LED medium flashing - Device is searching for a cellular network.
9) Data LED rapid flashing - Device is connected to a cellular network and transmitting/receiving data.
10) Data LED off (device has finished start-up sequence and is operational).
Warranty Information
WARNING: Any disassembly and reassembly will compromise sealing and void the warranty. For optimal
performance, please do not disassemble or modify this product.
FCC Warning statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(l) This device may not cause harmfulinterference; and
(2) This device must accept any interference received, including interference that may cause undesired operation..
Suppliers Name: Flex Industrial, Ltd.
Suppliers Address (USA): 6201 America Center Drive, San Jose, CA 95002, USA
Suppliers phone number: 408 576 7000
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. The maximum antenna gain for the licensed transmitter is <2.5dBi to ensure RFexposure
compliance is complied with ruled part power.