Getting Started Guide Wired trailer tracker 0 | Rev. 0.
Wired trailertracker Safety Warnings Read this complete guide before installing the device. This device contains a Lithium Ion battery. If these guidelines are not followed, the battery may experience a shortened life span or may present a risk of damage to the device, fire and/or bodily injury. —Do not penetrate the battery or device with a nail etc., nor make a hole in the battery.
LED The LED indicate device activity at start-up and its live functional status. Blue Green Red Off GPS Off Modem Off Device off or sleeping On GPS has location fix Connected to cellular network System is awake Rapid Flash Medium Flash Receiving GPS location Transferring cellular data Telematics transferring data (if Searching for satellites Searching for cellular network Device unlocked (3 sets of 4) Powering on the Device 1.
Troubleshooting Symptom Action LED slow flashes a repeated pattern of LED flashes after supplying power to the device The device is in error state; check the error codes above for corresponding actions LED doesn’t not illuminate after supplying power to the device.
Review this installation manual to become familiar with all installation procedures and electrical wiring requirements prior to starting the installation. This installation guide has been prepared to provide you with details necessary to complete the device installation. Use of proper tools and testing equipment is required. Never use a grounding style test light. Use only aDigital Multi Meter (DMM) to test wires in the vehicle.
duringcranking and while motor is running. Connect the device’s white/yellow wire here. Connector cable color table: Pin no. Cable definition Color 1 Ground Black CAR_BAT_PWR_12V_24V (12/24/48V (EV) Power 2 Red in) 3 Switched Input 1_CON (Ignition Detection) White/Yellow 4 Switched Output1 (Relay Control) Black/brown 5 RS232 TX1 Orange 6 RS232 RX1 Pink 7 1-wire_Line Yellow 8 12V_DC_OUTPUT (Switched power out) Purple 9 CAN_H1_CON (CANH (2.
2. For a solid connection, use a ring tongue terminal connector, star washer and a self-tapping screw. 3. Do not ground under existing bolts that hold brackets or panels in place. After wiring installation is complete, turn on the device by holding the power button for 2-4s until the power LED illuminates. You may see the device progress through a series of start-up steps, indicated by different LEDs as detailed below.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
