Owners manual

4. Mount the fan assembly to the radiator. Look for at least four potential mounting points that are able to
support the weight of the fan. Cross braces, radiator trays, front facia, and radiator mounting points are all
possible mounting points. Use the universal brackets and hardware kit supplied to hold the fan against the
radiator core. On some applications, the brackets may need to be cut or modified to fit. Additional holes may
need to be drilled as well.
WIRING INSTRUCTIONS;
7. Puller Configuration: (as shipped from the manufacture) Wire the fan motor to power source (control
unit or switch and relay if desired). Connect the Blue wire from the fan motor to a 24v. positive (+) source.
Connect the Black motor wire to a ground (-) source.
NOTE: Failure to do this will result in incorrect operation and damage to the fan motor!
8. Pusher Configuration: (reverse airflow)
A. Start by removing the fan blade retaining clip located on front hub at the motor shaft.
B. Then remove the fan blade and hexagon washers, flip blade and washers over.
C. Reinstall the hexagon washers and fan blade. Make sure the flat on the motor shaft is aligned with
the flat on the blade and washers. When re-installing the retaining clip, be sure the open end of the
clip is on the flat side of the motor shaft.
Note; Be sure hexagon washers are seated properly into
fan blade.
Wire the fan motor to power source (control unit or switch and relay if desired). Connect the Black wire from
the fan motor to a 24v. positive (+) source. Connect the
Blue motor wire to a ground (-) source.
NOTE: Failure to do this will result in incorrect operation and damage to the fan motor!
9. Connect an inline fuse holder; Be sure to connect the provided fuse holder in-line with the positive (+)
power wire to protect the fan motor and your vehicle's electrical system from damage.
Note: 15 - Amp fuse recommended
The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E. Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing user, that all Flex-a-lite products to be free of defects in material and
workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the point of
purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite will
replace the fan free of charge, transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary from state to state.
The Flex-a-lite warranty is in compliance with the Magnuson-Moss Warranty Act of 1975.
Rev. 04-12-10 #98024
5. Put the fan into place. Before tightening the brackets, adjust the fan so that the rubber seal is contacting
the radiator core and compress the seal about 50%. It may help to have an assistant hold the fan against the
core while tightening brackets.
6. Reconnect negative (-) battery cable to battery.