Installation&Assembly

#142 Flat Track Series Hardware
Visit our website at www.doorhdwe.com
for detailed installation instructions.
Step 7
Measure and locate hang-
er holes.
Important! For the door
to align with the track
stops, the hanger holes
at center must be 4-1/2”
from edge of door.
Mark the top and bottom
hole positions as shown in
the diagram.
Step 8
Using the Anti-Jump Block
as a guide, run the screw
in and out before install-
ing the hangers.
Step 9
Attach the hanger to the
door by inserting the
carriage bolts from the
back side. Secure with
acorn nut and washer, and
mount door on track.
Step 10
With the door in the open
position, place the Fin
Guide at the jamb open-
ing. If positioned cor-
rectly, the Fin Guide will
be concealed under the
door in the open or closed
position.
Step 11
Place the Anti-Jump Block
underneath the hanger in
alignment with the holes
and screw into place. Re-
peat the steps for the oth-
er hanger. Test Anti-Jump
by lifting the door.
Mark Fin Guide location
with the door plumbed
and in the open position.
Fin Guide
Anti-Jump
Block
Thank you for purchasing Flat Track by Leatherneck Hardware. We hope you enjoy your sliding
door hardware. If you have any questions during the installation process feel free to contact us at
888.442.4572 or refer to our Installation Guide and Video available on-line (www.doorhdwe.com).
Leatherneck Hardware, Inc.
P.O. Box 1142, Danville IL 61834
888.442.4572
402 Kit Installation Guide