Replacement Part List

Q12. What kinds of file formats does Adventurer 3 support?
Q14. Is the ABS printing safe?
Q15. How to solve if printing result has edge warp?
Q16. Is it a must to add a raft before printing the model?
Q17. After replacing nozzle completed, printer status displays extruder temperature
is 300℃, extruder fan is also working, what is the problem and how to slove?
The new nozzle is not properly installed, extruder temperature can not be read and the
displayed extruder temperature is abnormal. Please plug out and install the nozzle again,
push nozzle to the end, make sure the nozzle slot and bottom of extruder are on the same level.
Q13. Does Adventurer 3 support other cloud platform besides the FlashCloud?
Yes , Adventurer 3 interface is open up to all other cloud platforms.
ABS filament will give off certain poisonous gas when heated up, please put the printer in
well ventilated condition when printing ABS. We suggest printing non-toxic PLA filament
when printer is used in children activity places.
Method1: Heating up the platform can solve or minimize the problem by increasing
adhesion between platform and model.
Method2: Adding raft to model when slicing in FlashPrint.
Method3: Apply the solid glue to platform before printing.
Not necessarily, much more filament will come out of extruder when printing the raft,
increasing printing success. Heating up the platform also increases printing success by
increasing adhesion between platform and model.
Input: 3mf / stl / obj / fpp / bmp / png / jpg / jpeg files.
Output: gx/g files.
Q18.The extruder makes out chug noise and no filament come out of extruder, what is
the problem and how to slove ?
Filament has not loaded into extruder, making out chug noise,more likely the nozzle is clogged
or filament guide tube is not properly installed. Check the guide tube joint first, if the guide tube
is normal, refer to Q1 for resolution.
Load: Only include loading filament into extruder;
Replace: Include loading and unloading two functions, first unloading and then loading filament.
Q19.What is the difference between filament load and filament replace ?
Do the printer Calibration again or do the Homing again, then print again to check result.
Q20.Adventurer3 starts printing when the distance between extruder and build plate is
still large,causing filament can not stick to build plate and print fails.
USB driver file is not corrected. Adventurer3 only supports FAT32 file system, please format USB
driver into FAT32 file system.
Q21. You cannot find printing files when you use USB driver.
47