FL3DFFGNPRO User Manual

７
Congratulations! You have completed the initial hardware installation! If you're ready to start printing, proceed to the
next step: Software Installation.
4 Software Installation
ReplicatorG0040 is the ideal software to use with the dual extruder Creator Pro. It can be downloaded from our official
website by following the link below and click on Download.
http://replicat.org/download
ReplicatorG0040 for Windows users can also be found in the folder of information of 3D printer on the SD card, which
shipped together with the Creator Pro.
Steps for installing your software:
1. Download the appropriate version of ReplicatorG suitable for your system from
http://replicat.org/download.
2. From the SD card shipped with your printer, browse to the “information of 3D printer” folder and run the
Python installation file and the Python acceleration components.
3. After completing the Python component installation, click Replicator-0040-Installer to install the
ReplicatorG software.
4. To run the ReplicatorG software, double click the shortcut on your desktop or in your start menu.
SPECIAL NOTES TO WIN 8 USERS BEFORE SOFTWARE INSTALLATION
Win 8 users please make sure that you have disabled the Driver Signature Enforcement setting before installing
the ReplicatorG software. Below is a video link showing you how to accomplish this:
http://www.youtube.com/watch?v=NM1MN8QZhnk