FL3DFFGNPRO User Manual

２
1 What's Included in the Box?
Along with your Creator Pro 3D printer, the box also contains the following:
In the two long boxes on the top of the package, you’ll find:
 Power cord x 1pc,
 USB A to B cable x 1pc,
 Sensor Line x 1pc,
 Filament guide tube x 2 pcs.
 Filament spool holder x 2 pcs.
In the Creator Pro Acrylic Accessory box:
●
Acrylic sheet x6 pc
● Handle x1 pc
● Accessory bag x1 pcs
An accessory box on the top of the Creator Pro:
 Dual extruder heads x 1pc,
 4G SD card x 1 pc,
 Blue tape x 1 pc,
 Bolt, hex wrench and screws kit x 1 bag.
Under Creator Pro’s build platform, there are 2 rolls filament:
 White ABS filament x 1kg (2.2pounds),
 Blue PLA filament x 1kg (2.2pounds),
2 Un-boxing
The Creator Pro was carefully packaged at FLASHFORGE manufacturing facility. Please follow the unboxing steps laid
out below.

First, put the box on the floor in a clean and flat surface. Remove the top two long boxes and set them aside. You will
find a power cord, 1 USB A to B cable, 1 sensor line,2 filament guide tubes, and 2 spool holders in these two long
boxes.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the thin yellow film from the heating plate. It is heat resistant tape that improves the
adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and heat resistant
tape that helps to keep the nozzle at a constant temperature.