FL3DFFGNPRO User Manual

１７
Feed operation with LCD screen
4. Select Filament loading; press the OK key of the keypad. The display will show:
▶ Load Right
Unload Right
Load Left
Unload Left
5. Select the appropriate side of the extruder you wish to load(Left or Right for models with dual extruders).
Press the OK key again on the keypad. The display will indicate: I'm heating up my extruder!” At this time, the
temperature of the right nozzle is being heated up. When the temperature of the nozzle reaches its target
temperature, pressing the OK key on the keypad, and the nozzle should start extruding material. If not, keep
pressing the OK key unit it does.
6.3 Withdrawing the Filament Using LCD Screen
1) Turn on the Creator Pro, the display will indicate:
Build from SD
▶
Preheat
Utilities
2) Using the directional arrows to the right of the screen, press page down key to scroll to the next page and
select Preheat, Press OK key on the keypad, then you will see
：
▶ Start Preheat
Right Tool OFF
Left Tool OFF
Platform OFF
3) Press page down key to select Left Tool (or Right Tool), click OK key, you will see
：
▶Start Preheat
Right Tool ON
Left Tool ON
Platform OFF
4) Press page up key back to Start Preheat, and Press OK key, you will see:
Heating:
R Extruder: 033/230C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 220°C. First push in the filament a little bit until you see
filament come out of the nozzle, then pull it out quickly. This will ensure you have withdrawn the filament inside the
nozzle successfully.
6.4 Feeding the Filament Using Replicator G Control Panel
The following can only be performed while the printer is connected to the computer.
Open the Replicator G software, click the icon in the red box, this is the control panel icon. The dialogue box shown
below will then pop up.
CAUTION
If you just finished your printing or already extruded the filament and want to withdraw the filament, at this
moment, the extruder is still over 200°C, first push the filament in a little further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then load in. Please
do as following shown to avoid filament jam.