User's Manual
Table Of Contents
- Content
- Preface
- Introduction
- Notice
- Chapter 1: 3D Printing Technology
- Chapter 2: About GuiderIIS
- Chapter 3：Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- 6.2.4 Views
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.10 Print
- 6.2.11 File Menus
- 6.2.12 Edit Menus
- 6.2.13 Print Menus
- 6.2.14 Tool Menus
- ① Control Panel
- ② Update Firmware
- NOTE！Please update firmware under instructions of
- ③ On Board Preferences
- ④ Machine information
- 6.2.15 Help Menus
- Chapter 7: Basic Printing
- Chapter 8: Supports and Service
- Chapter 9:Basic Questions and Answers
- Note! Do not disassemble the printer for maintenan
- 9.1 Extruder shakes from left and right when print
- 9.2 “1025” extruder temperature showed on printer’
- Step 1. Extruder thermocouple has loose contact or
- 9.9 Wave-like lines appear on the surface of model
- 1. Apply some lubricate grease on the Z-Axis.
- 2. Z-Axis guide rods and Z-Axis bearings do not co
- 9.10（1）One of the axis motor is not working or rot
- 9.12 Files sliced by Flashprint and transferred by
- 9.13 Print results shift along the direction of X-
- 9.14 When doing build plate leveling, touch screen
GuiderIIS User Guide | www.flashforge.com 400-699-1063
Click [MANAGE] button on the right upper position of this printer’s details webpage.
Then click [SETTINGS] button on the right upper position of the next webpage.
Finally, drag the next page to bottom down, click [DELETE PRINTER] button.
After you’v completed the above delete steps, this printer can now be used by others
under his own polar cloud account.