User's Manual
Table Of Contents
- Content
- Preface
- Introduction
- Notice
- Chapter 1: 3D Printing Technology
- Chapter 2: About GuiderIIS
- Chapter 3：Unpacking
- Chapter 4: Hardware Assembly
- Chapter 5: Build Plate Leveling
- Chapter 6: About Software
- 6.1 Software Installation
- 6.2 Exploring FlashPrint
- 6.2.4 Views
- ①Changing views
- ②Set View
- ③Reset View
- ④Show Model Outline
- ⑤Show Steep Overhang
- 6.2.5 Move
- 6.2.6 Rotate
- 6.2.7 Scale
- 6.2.8 Cut
- 6.2.9 Supports
- ②Auto Supports
- ③Add Supports
- ④ Clear Supports
- Click [Clear Supports], all supports will be delet
- ⑤Delete Supports
- 6.2.10 Print
- 6.2.11 File Menus
- 6.2.12 Edit Menus
- 6.2.13 Print Menus
- 6.2.14 Tool Menus
- ① Control Panel
- ② Update Firmware
- NOTE！Please update firmware under instructions of
- ③ On Board Preferences
- ④ Machine information
- 6.2.15 Help Menus
- Chapter 7: Basic Printing
- Chapter 8: Supports and Service
- Chapter 9:Basic Questions and Answers
- Note! Do not disassemble the printer for maintenan
- 9.1 Extruder shakes from left and right when print
- 9.2 “1025” extruder temperature showed on printer’
- Step 1. Extruder thermocouple has loose contact or
- 9.9 Wave-like lines appear on the surface of model
- 1. Apply some lubricate grease on the Z-Axis.
- 2. Z-Axis guide rods and Z-Axis bearings do not co
- 9.10（1）One of the axis motor is not working or rot
- 9.12 Files sliced by Flashprint and transferred by
- 9.13 Print results shift along the direction of X-
- 9.14 When doing build plate leveling, touch screen
GuiderIIS User Guide | www.flashforge.com 400-699-1063
Load files.
Enter the support edit mode
Print it directly with your GuiderIIS or export to your USB Stick
View FlashPrint home screen from one of six viewing angles
Move model around on XY-plane; shift+click to move along Z axis
Turn and rotate your model
Scale the size of your object
Cut model into several parts
6.2.3 Loading
You can load a model file or Gcode file into your FlashPrint by the following six
methods:
Method 1: Click the [Load] icon on the main interface. Then select the
object file.
Method 2: Select the file for loading and drag the file to the main interface of the
software.
Method 3: Click [File]--[Load File]. Then select the object file for loading.
Method 4: Click [File]--[Examples] to load the example files
Method 5: Click [File]--[Recent Files] to load the files opened recently.
Method 6: Select and drag the target file to the icon of FlashPrint.