User's Manual

GuiderIIS User Guide | www.flashforge.com 400-699-1063
Polar Cloud Connection:
Cloud Connection: To turn on/off the polar
cloud connection.
Setup Cloud Connection: To set cloud
connection ID and PIN which have already
been registered on: https://polar3d.com
ID: The email address of your Cloud
account.
PIN: The PIN code of your Cloud account.
Save: To save the setting.
Back
(Note: To use polar cloud printing function,
you need to connect the printer to internet
with WiFi or Ethernet Cable first)
Extruder Calibration:
(not recommended for customers to operate)
To adjust the initial distance between the
extruder and the build plate by tapping
[-]and[+]. The proper distance may be one
ordinary paper’s thickness.
Turn on [Filament Check]:
Left picture showed is the [Filament
Check] turned on status.
Filament abnormal status will be detected
when filament is used up or suspended.
[Filament Check] function should be used
with filament in the filament cartridge.This
function is invalid if using filament out of
the cartridge.