User Manual

GuiderⅡ User Guide | www.flashforge.com 400-699-1063
52
If successfully connected, you will see the following red mark.
②Connect Guider Ⅱ with your PC under STA mode
a. Tap [Tools]-[Setting]-[WiFi]-[WiFi ON] to turn on the WiFi of Guider II and
connect your computer and Guider II with the same WiFi signal.
b. Click [Print]-[Connect Machine] on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
6-18
If successfully connected, you will see the following red mark.
6-19
Disconnect GuiderⅡ
Click [Print]--[Disconnect] to disconnect your PC and GuiderⅡ.
6.2.14 Tool Menus
①
Control Panel
After connecting PC with GuiderⅡ, click [Tools]--[Control Panel] to open the
control panel.