User Manual

GuiderⅡ User Guide | www.flashforge.com 400-699-1063
51
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, it means you haven’t installed the driver in the software.
6-18
Method 2： Connect Via WiFi
①Connect Guider Ⅱ with your PC under AP mode
a.Turn on your Guider
Ⅱ
b. Tap [Tools]-[Setting]-[WLan hotspot]-[WLan hotspot ON].
c. Click on the wireless network setting in your computer, and find the wireless
signal-“Guider
Ⅱ
”. Click [Connect] to connect your computer with Guider
Ⅱ
via
Wlan hotspot.
d. Click [Print]-[Connect Machine] on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
6-19