User Manual

GuiderⅡ User Guide | www.flashforge.com 400-699-1063

Cooling Fan Control: Set up the time to turn on the cooling fan. You can

pre-set the height and make the cooling fan begin to work at the point.

Pause At Heights: Allows users to pre-set a height in which the print will

suspend automatically. The function usually applied when you want to change the

filament at a certain point.

(6-14) Click [Edit], then you can add or remove a height.

6.2.11 File Menus

①New Project

Click [File]--[New Project] can build a blank project. If there is an unsaved

modification on previous project, then it will inform you whether the modification

needs to be saved or not. Click [Yes] will save the modification, while click [No] will

abandon it. If click [Cancel] or close tool tip, then will cancel the new project.

②Saving

After finishing the model edit and adjustment, there are two ways below to save all

models in the scene.

Method 1:

6-15

6-14