User Manual

GuiderⅡ User Guide | www.flashforge.com 400-699-1063

Chapter 4: Hardware Assembly

Your GuiderⅡ has been installed before leaving factory, you can start up the GuiderⅡ

for printing after mounting the filament spool and completing leveling.

4.1 Filament Installation

4-1

(4-1) The filament cartridge is at the rear of GuiderⅡ. Lift the cartridge out of the

Guider

Ⅱ

4-2

(4-2) Take out the filament and thread it through the filament detecting equipment.

(Note: The filament should feeds from the bottom of the spool towards the top )

Filament Detecting

Equipment in the black.