Quick Start Guide

Heating extruder...
1. Tap [Filament], tap [Change], extruder starts preheating. 2. Open the filament cover.
3
. Pull out the filament as the picture
showed above.
5
. Tap [ok] after plugging in new filament, loading starts.
When new filament come out of extruder steadily,
replace is completed, tap [OK].
4. Insert new filament into the filament intake
and push the filament into the feeding wheel
until resistance is sensed.
Load
Change
200
/235℃
Cancel
Change Filament
6. Put the spool of filament
on the spool holder, close
the filament cover.
235
/235℃
OK
235
/235℃
OK
Pull out filament,
feed new filament, press [OK]
Press ok when new color appears
10