User manual

Finder User Guide | www.flashforge.com 400-699-1063
19
Extruder Calibration
Adjust Z-axis to the right position and tap
[OK]
 +: The build plate elevates.
 -: The build plate descends.
OK: To save the setting and back to setting
menus.
 Back
The proper distance may be one ordinary
paper’s thickness.
Note: Please do this operation after
contacting with our after-sale engineer.
Turn on/off [Startup Sound]:
Tap to turn on/off the sound when restart
the printer.
Filament Check On:
The filament detection is turned on.
Note: Filament exhausted or interrupted
will be detected. Once the filament is not in
the right place, the print job can not work
normally.
Filament Check Off:
The filament detection is turned off.
Note: Filament exhausted or interrupted
cannot be detected.The print job can still
work normally when filament is not set into
the filament cartridge.
Turn on/off [Light Bar Control]:
Tap to turn on/off the light bar when restart
the printer.
Power Saving Mode On
The power saving mode status is turned on.
If there is no operation within half an hour,
the printer will automatically shut down.
(Power saving mode will not work in the
process of printing)