User Guide

Product Warnings and Safety Precautions
Keep in mind that this chase light controller runs on electricity, so you DO need to take all of the
necessary safety precautions when handling this controller that you would when handling any
electrical device.
➢ Always unplug the controller before removing the cover and before adjusting the dip switch
settings.
➢ When using the controller outside, always mount it at least 12 inches off the ground.
o This controller cannot sit in a puddle of water.
o If water gets inside the controller box, it could not only damage the controller, but could
also result in electrocution IF you handle the box before unplugging it.
o Make sure you are standing on a dry surface when handling the controller while it is
plugged in.
➢ Always plug the controller into a 3-prong outlet that is on a GFI protected circuit.
o Do not plug the controller into a receptacle on a rip cord.
o Do not remove the safety ground pin from the controller’s plug.
If the inside of the controller gets wet, unplug the controller, remove the cover, and let it dry out. (You
can use a heating vent or hair dryer.)
➢ Do NOT run the controller while the inside is wet – this can result in permanent damage to the
controller’s circuit board.
3TSC-10 Manual p14