Installation Manual

POWERFLARM FUSION
INSTALLATION MANUAL
Date: 2020-11-27
Version: 1.1
Page: 28 of 40
FLARM Technology Ltd
Hinterbergstrasse 15
CH-6330 Cham
Document Number:
FTD-077
 Fusion is not supported by the PC software FLARM Tool for Classic FLARM.
Firmware updates, IGC file downloads, and obstacle data uploads cannot be
done via the data ports. Instead, they are done via FLARM Hub or with a USB
flash drive. The USB extension cable should be installed in the instrument
panel. USB data transfer is also faster than over the data ports. See the User
and Maintenance Manual for details.
4.5 Conformity Declarations
4.5.1 CE
FLARM Technology Ltd, Hinterbergstrasse 15, CH-6330 Cham, Switzerland,
declares that the product PowerFLARM Fusion FLAFUS10W, produced by Placetec
AG, Industriestrasse 17, CH-4410 Liestal, Switzerland, is designed to comply with
the following standards and norms: EN 62368-1:2014+A11:2017, EN 300 328
V2.2.2, EN 301 489-1 V2.2.3, EN 301 489-17 V3.2.4, EN 301 489-19 V2.1.1, EN
301 489-3 V2.1.1, EN 300 220-2 V3.1.1, EN 62311:2008.
4.5.2 FCC
Report Number: T251-0695/20
Product: Radio Module
Type reference: PowerFLARM Fusion
FCC ID: 2AXJM-FLAFUS10W
Ratings: 12-32 V DC
Operating frequencies: 902,6 MHz – 927,4 MHz
Protection class: III
Trademark: FLARM
Applicant: FLARM Technology Ltd, Hinterbergstrasse 15, CH-6330
Cham, Switzerland
Manufacturer: Placetec AG, Industriestrasse 17, CH-4410 Liestal,
Switzerland
Testing method: 47 CFR Part 15, Subpart C (Clause 15.247) in
conjunction with ANSI C63.10:2013
This device complies with Part 15 of the FCC. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may
cause undesired operation.