User's Manual

Chapter 4: Connecting the Power System
Figure 4-2: Conduit for Power Cable — Rear View
1.
Open the rear door of the cabinet using the handle hex tool ke y.
2.
Route the ca ble through the side conduit connector hole into the 1” flexible conduit provide d.
3.
Interface to the 1” bulkhead conduit fitting provided on the outside of the ca binet with a
conduit pull box w ith hole diame ter 1.375” to 1.50”. The interface must be leak tight.
4.
Route the cable through the flexible conduit up to the AC load center.
RadioRouter® Base Station Outdoor I nstallation Guide © 2005 Flarion
Flarion Proprietary and Confidential
Page 4-2