User's Manual
Table Of Contents
- toc
- Issue Date: 09- 23- 2003
- Overview
- 1.1. Installation Equipment
- Verifying the Site Preparation
- 2.1. Site Preparation Checklist •24 Outdoor BaseStation
- 2.2. Preparing the Floor
- Installing the Cabinet
- Connecting the Power System
- Connecting the Core Network Cables
- Connecting the Antennas
- Powering Up the Cabinet
- Powering Down the Cabinet
- Verifying the Installation
- RadioRouter Outdoor BaseStation Site Preparation Punchlist
- Outdoor BaseStation Installation Punchlist
- tables
Page 13
Figure 4.2 Path of Power Cable to AC Load Center — Rear View
1.
Open the rear door of the cabinet using the handle hex tool key.
2.
Route the cable through the side conduit connector hole into the 1” flexible conduit provided.
3.
Interface to the 1” bulkhead conduit fitting provided on the outside of the cabinet with a
conduit pull box with hole diameter 1.375” to 1.50”. The interface must be leak tight.
4.
Route the cable through the flexible conduit up to the AC load center.
RadioRouter
®
BaseStation Installation Guide — Draft
Version 0.2 - © 2003 F larion
Flarion Confidential
Page 13